Fixed Point Clamp FS

Group: 1380

This is a replacement for Old Productname (Part number 123456).

For fixed point installations in combination with mounting kits

Absorbs axial loads in both directions thanks to symmetric construction

Mounting kit and braces required; dimensioning advice available for loads up to 35 kN

Select a Type

Overview of Types
General Information
Installation

Overview of Types

General Information

To be used for Fixed Point installations in combination with Mounting Kits. For completion a Mounting Kit (with or without sound absorption) and 4 braces (Sikla threaded tubes or rods) are needed. For professional dimensioning of these components according to fixed point loads (up to 25 kN with sound absorption or up to 35 kN without sound absorption) our staff members give advice. The symetric construction enables absorption of axial loads in both directions. The centrically welded M16 nut offers further connection possibilities.

Certification

Technical specifications

Primary element material	steel
Connecting element material	steel
Surface finish	electro galvanized (Fe//Zn)
Corrosion protection class	C2

Software

This product is available in the following software.

Installation

Tighten clamping bolts equally with the torque M as mentioned in the table.

Note: Tightening torque for combination FP clamp with steel pipe DIN EN 10220 / normal wall thickness. For pipes with smaller wall thickness or other material, the values have to be reduced.

Type	Tightening torque
21,3 ... 48,3	50 Nm
57 mm ... 88,9	80 Nm
108 mm ... 521 mm	100 Nm